Offset Clock by Simon Hope

In April 2012 Simon Hope demonstrated turning the Offset Clock.

In the Photo Galleries there are detailed sequence photos which show how this was done.

This video supplements these photos and uses a CAD program to show the curves cut and comments on some points to watch out for.

Just in case … it includes sound/audio … and can also be viewed at full screen size.

If you are going to try this remember that with offset turning the mass on the lathe is out of balance – you are also creating sharp edges which are spinning rapidly – be careful…

It is my first attempt at using both the drawing and the video programs – they will get better!

Leave a Reply

October 2021
S M T W T F S
« Mar    
 12
3456789
10111213141516
17181920212223
24252627282930
31